Subaru Legacy BN/BS (2015-2019) Service Manual: Removal

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Front regulator and motor assembly / Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE

2. Remove the trim panel - front door. Door Trim > REMOVAL

3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL

4. Remove the glass assembly - front door. Front Door Glass > REMOVAL

5. Remove the regulator and motor assembly - front.

(1) Disconnect the motor - front connector.

(2) Remove the bolts, and then remove the regulator and motor assembly - front.

Front regulator and motor assembly

...

Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.• LH sideTerminal No.Inspection conditionsStandard6 (+) — 3 (−)Apply battery voltage between ...

Other materials:

Installation
1. Install the knock sensor to the cylinder block, and connect the connector to the knock sensor.NOTE:• Install the knock sensor connector so that the center of the connector is aligned with the extension line from the cylinder block rib (a).• Make sure that the knock sensor and its conn ...