Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Front regulator and motor assembly / Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.

• LH side

Terminal No.	Inspection conditions	Standard
6 (+) — 3 (−)	Apply battery voltage between terminals.	Increase
3 (+) — 6 (−)	Apply battery voltage between terminals.	Decrease

• RH side

Terminal No.	Inspection conditions	Standard
1 (+) — 4 (−)	Apply battery voltage between terminals.	Increase
4 (+) — 1 (−)	Apply battery voltage between terminals.	Decrease

2. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - front.

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOVAL3. Remove the sealing ...

Installation

1. Install the regulator and motor assembly - front.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the glass assembly - front door. Front Door Glass > INSTALLATION3. Install the se ...

Other materials:

Diagnostics with phenomenon inspection
SymptomsFaulty partsStall speed is low after warming-up, with select lever in “D” or “R” range.Engine control systemVehicle does not move despite engine speed rising up, with select lever in “D” or “R” range.• Engine control system• Select ...