Subaru Legacy BN/BS (2015-2019) Service Manual: Replacement
1. Release the parking brake. 2. Using the Subaru Select Monitor, go to the brake maintenance mode according to the display screen. Parking Brake System > OPERATION NOTE: For detailed operation procedures, refer to “Application help”. 3. Disconnect the ground terminal from battery sensor. NOTE 4. Remove the pad - disc brake rear. Rear Brake Pad > REMOVAL 5. Press back the piston - disc brake. 6. Install the pad - disc brake rear. Rear Brake Pad > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE 8. Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen. 9. After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally. NOTE: Perform the following replacement procedure if the Subaru Select Monitor cannot be used. (1) Remove the disc brake assembly and the pad - disc brake rear. (2) Remove the bolt securing the lower side of the support - rear disc brake, loosen the upper side bolt, and then slide the support - rear disc brake upward and hold it. (3) Secure the disc brake assembly as shown in the figure, and push back the piston using the tool.
(4) Install the support - rear disc brake and the disc brake assembly to the specified tightening torque. Tightening torque: Refer to “COMPONENT” of “General Description”. General Description > COMPONENT |
Rear brake pad
...
Inspection
1. Check the thickness of the pad - disc brake rear.NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.• Replace th ...
Other materials:
Dtc b2a01 lte1 antenna circuit
DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Any of the followings continues for 5 seconds or more.• LTE1 impedance is more than 1 M-. (Detached antenna, etc.)• LTE1 impedance is less than 1 k-. (Short-circuited antenna, etc.)TROUBLE SYMPTOM:• Telema ...
