Subaru Legacy BN/BS (2015-2019) Owners Manual: Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the access key/remote transmitter is used only for locking and unlocking the doors and rear gate (Outback) and panic activation. To enter the valet mode, change the setting of your vehicle's alarm system for deactivation mode. Refer to "Activating and deactivating the alarm system" 29. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode. To exit valet mode, change the setting of your vehicle's alarm system for activation mode. Refer to "Activating and deactivating the alarm system" . |
Disarming the system
Perform either of the following procedures.
Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
Carry the access key and perform
eit ...
Tripped sensor identification
The security indicator light flashes when
the alarm system has been triggered.
Also, the number of flashes indicates the
location of unauthorized intrusion or the
severity of impact on the vehic ...
Other materials:
Procedure
1. INITIALIZATIONNOTE:Perform the initialization of the power rear gate auto closer, if the battery ground cable is connected with the rear gate open. Initialization is not required when the battery ground cable is connected with the rear gate closed.1. Turn the ignition switch to OFF.2. Close the r ...
