Subaru Legacy BN/BS (2015-2019) Owners Manual: Disarming the system
Perform either of the following procedures.
The flashing of the security indicator light will then change slowly (once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed. Emergency disarming If you cannot disarm the system using the transmitter (i.e. the transmitter is lost, broken or the transmitter battery is too weak), you can disarm the system without using the transmitter. The system can be disarmed if you turn the ignition switch from the "LOCK"/"OFF" to the "ON" position with a registered key/ access key. NOTE For models with "keyless access with push-button start system", if the access key battery is discharged, perform the procedure described in "Switching power status" . In such a case, replace the battery immediately. Refer to "Replacing battery of access key" F11-50. |
To arm the system using the keyless access function (if equipped)
Close all windows and the moonroof (if
equipped)
Turn the push-button ignition switch to
the "OFF" position.
Open the doors and get out of the
vehicle.
Make sure that ...
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the access key/remote transmitter
is used only for locking and unlocking the
doors and rear gate (Outback) and pan ...
Other materials:
Inspection
1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION2. Disconnect the Subaru Select Monitor. While bringing the access key, operate the touch sensor on door handle to check if door lock or unlock operates.3. Disconne ...
