Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. Using the ST, install the taper roller bearing (transfer case side). CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton). NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.
2. Using the ST, install the taper roller bearing (extension case side). CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton). NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.
|
Removal
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL3 ...
Installation
1. Install the taper roller bearing (transfer case side) outer race.(A)Taper roller bearing (transfer case side) outer race2. Apply a coat of grease to the taper roller bearing (transfer case side) of ...
Other materials:
Dtc p0970 pressure control solenoid "c" control circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Drivability getting worse.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK HARNESS.CAUTION:Start work after ATF cools down.1) Turn the ignition switch to OFF.2) Disconn ...
