Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the taper roller bearing (transfer case side) outer race.
2. Apply a coat of grease to the taper roller bearing (transfer case side) of transfer driven gear and the roller rolling surface of the taper roller bearing (extension case side). Grease: NICHIMOLY N-130 or equivalent 3. Install the transfer driven gear and center differential as a unit.
4. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION 5. Install the selected adjusting washer and taper roller bearing (extension case side) outer race to the extension case. 6. Install the transfer case and the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION 7. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION 8. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION |
Assembly
1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling because the taper r ...
Inspection
1. Taper roller bearingReplace the taper roller bearing in the following cases.• In case of broken or rusty taper roller bearings• In case of worn or damaged taper roller bearings• W ...
Other materials:
Installation
1. Install the stop light switch onto the bracket with screws and position it with the nut.2. Adjust the stop light switch position, and then tighten the nut. Stop Light Switch > ADJUSTMENTTightening torque:8 N·m (0.8 kgf-m, 5.9 ft-lb)3. Install the panel - knee guard.Tightening torque:7 N&m ...
