After repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module. 1. AIRBAG SYSTEM 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Airbag» and select «Enter». 5. On «Airbag» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For detailed operation procedures, refer to “Application help”. 2. OCCUPANT DETECTION SYSTEM 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Occupant Detection» and then select «Enter». 5. On «Occupant Detection» display, select «DTC». 6. On «DTC» display, select «Clear Memory». NOTE: For detailed operation procedures, refer to “Application help”. |
Check list for interview check
Electrical component location locationInstallation
CAUTION:• For parts which are not reusable, always use new parts.• Check the bushing for abnormal cracks, fatigue or damage.1. Install the strut mount - front at the upper side of the strut to the body, and tighten it with new flange nuts.Tightening torque:20 N·m (2.0 kgf-m, 14.8 ...