Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Check that the operating cylinder is not damaged. Replace the operating cylinder if it is damaged. 2. Check the brake fluid leakage on the operating cylinder or the boot for damage. Replace the operating cylinder if brake fluid leaks or boot damages are noted. |
Installation
NOTE:• Use a new gasket.• Be sure to install the clutch hose with the mark side facing upward.• Be careful not to twist the clutch hose during installation.• Before installing ...
Disassembly
1. Remove the boot and push rod.2. Apply compressed air through clutch hose attachment hole.NOTE:Face the piston hole down and place a piece of wood underneath to prevent the piston from popping out.3 ...
Other materials:
Dtc p0506 idle control system rpm - lower than expected
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start the engine.• Engine does not start.• Improper idling• Engine stalls.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory ...
© 2017-2026 Copyright www.sulegacy.com
