Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Visually check the harness and connector for damage or crack. 2. Check the harness terminal for rust, disconnection or poor contact. 3. Check the continuity between harness terminals and oil temperature sensor. NOTE: Refer to WIRING SECTION for transmission harness terminal and oil temperature sensor terminal. CVT Control System > WIRING DIAGRAM Harness continuity standard: Less than 1 - Oil temperature sensor standard: Approx. 2.6 k- (at 20°C) |
Removal
1. Remove the transmission from the vehicle. Automatic Transmission Assembly > REMOVAL2. Prepare for overhaul. Preparation for Overhaul3. Remove the transmission harness ground terminal and remove t ...
Installation
1. Install the harness clip to the transmission assembly.2. Insert the transmission harness bushing into the round hole on the transmission case and install the bolt.NOTE:• Use new O-rings.&bull ...
Other materials:
Dtc p0116 engine coolant temperature sensor 1 circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspectio ...
