Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. The shift lock operates normally. AT Shift Lock Control System > INSPECTION 2. Engine starts when the select lever is in “P” or “N” range, but not in other ranges. 3. Back-up light illuminates when the select lever is in the “R” range, but not in other ranges. 4. Select lever and indicator positions are matched. 5. Make sure that the door open alarm will not sound when the door is opened in the “P” range after the ignition switch is turned to OFF. NOTE: If the door open alarm sounds, check if the rod COMPL is inserted in the wrong direction. |
Removal
1. Shift the select lever to “N” range.2. Disconnect the ground terminal from battery sensor. NOTE3. Lift up the vehicle.4. Remove the center exhaust pipe. (2.5 L model) Center Exhaust P ...
Installation
1. Insert the indicator light terminal to the harness connector.(A)Indicator light (color code: red/white)(B)Indicator light (color code: blue/white)2. Install the housing and the blind.3. Install the ...
Other materials:
Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the "ON"
position then move the select lever to the
"P" position with the select lever button
pressed and brake pedal depressed.
If the select lever does not move after
performing the above procedure, perform
the follo ...
