Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Combination switch (light) / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

• Lighting switch

Terminal No.	Inspection conditions	Standard
18 — 12 19 — 12 20 — 12	Switch OFF	1 M- or more
19 — 12	Switch AUTO	Less than 1 -
18 — 12	Switch 1 (PARKING)	Less than 1 -
18 — 12 20 — 12	Switch 2 (HEAD)	Less than 1 -

• Dimmer & passing switch

Terminal No.

Inspection conditions

Standard

11 — 12

17 — 12

Switch PASS

Less than 1 -

11 — 12

Switch UP

Less than 1 -

• Turn signal switch

Terminal No.	Inspection conditions	Standard
13 — 12	Switch TURN (RH)	Less than 1 -
15 — 12	Switch TURN (LH)	Less than 1 -

• Front fog light switch

Terminal No.	Inspection conditions	Standard
4 — 3	Switch OFF	1 M- or more
4 — 3	Switch ON	Less than 1 -

2. Replace the switch assembly - combination turn dimmer if the inspection result is not within the standard value.

Removal

CAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION1. Set the tire ...

Installation

CAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION• ...

Other materials:

Assembly
CAUTION:• Do not confuse the harness routing in the reverse side of the seat cushion. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the hook - spring of the frame assembly - front backrest is deformed or comes off due to the deformatio ...