Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • Do not allow harness and connectors to interfere or get tangled up with other parts. • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT 1. Install the switch assembly - combination turn dimmer. 2. Install the switch assembly - combination wiper select. 3. Install the steering roll connector. Roll Connector > INSTALLATION 4. Install the cover assembly - column. 5. Install the steering wheel. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 6. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit tester• Lighting switchTerminal No.Inspection conditionsStandard18 — 1219 — 1220 — 12Switch OFF1 M- or more19 ...
Other materials:
Installation
1. Install the intake manifold onto cylinder heads.NOTE:Use a new gasket.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)• RH side• LH side2. Install the bolts securing the EGR pipe B to the EGR control valve.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 f ...
