Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Day time running resistor / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

1 — 2

2 — 3

Always

1.82±0.07 -

2. Replace the resistor assembly - daytime running light if the inspection result is not within the standard.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the bumper face - front. Front Bumper > REMOVAL3. Remove the resistor assembly - daytime running light.CAUTION:The resistor may b ...

Installation

CAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).1. Install the r ...

Other materials:

Inspection
1. SATELLITE SWITCH ASSEMBLY1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 2VOL (+)VOL (−)SEEK ()SEEK ()LISTRETURNA circuit is all OFF.Approx. 100 k-VOL (+)ONLess than 1 -VOL (−)ONApprox. 50 -Preset CH U ...