Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / High-mounted stop light / Inspection

1. Apply battery voltage between the connector terminals to check the lighting condition of the light.

• Sedan model

Terminal No.	Inspection conditions	Specification
1 (+) — 2 (−)	Apply battery voltage.	Light ON

• OUTBACK model

Terminal No.	Inspection conditions	Specification
1 (+) — 2 (−)	Apply battery voltage.	Light ON

2. Replace the light assembly - high-mounted if faulty is found in the inspection.

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel assembly - rear shelf. Rear Shelf Trim > ...

Installation

1. SEDAN MODEL1. Install the light assembly - high-mounted.2. Install the trim panel assembly - rear shelf. Rear Shelf Trim > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE2. OUT ...

Other materials:

Inspection
1. Check that the fuel sub level sensor has no damage.2. Measure the fuel sub level sensor float position.(1)FULL(2)EMPTY(3)Datum pointsFloat positionStandardFULL to Datum point (A)6.4±3.5 mm (0.252±0.138 in)EMPTY to Datum point (B)163.3±3.5 mm (6.429±0.138 in)3. Measure the resistance between f ...