Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Switches and harness / Inspection

1. BACK-UP LIGHT SWITCH

1. Turn the ignition switch to OFF.

2. Disconnect the back light switch connector.

3. Measure the resistance between the back-up light switch terminals.

Gear shift position	Terminal No.	Specified resistance
Reverse position	1 and 2	Less than 1 -
Other positions	1 and 2	1 M- or more

4. Replace faulty parts.

2. NEUTRAL POSITION SWITCH

1. Turn the ignition switch to OFF.

2. Disconnect the connector of neutral position switch.

3. Measure the resistance between neutral position switch terminals.

Gear shift position	Terminal No.	Specified resistance
Neutral position	1 and 2	Less than 1 -
Other positions	1 and 2	1 M- or more

4. Replace faulty parts.

Removal

1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intak ...

Installation

1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Install the back-up light switch & neutral position switch with the harness.NOTE:Use a new gasket.Tightening torque:32.3 N·m (3.3 kgf-m, 23.8 ft-l ...

Other materials:

Note
• The on-board diagnostic (OBD) system detects and indicates a fault in various inputs and outputs of the complex electronic control. Malfunction indicator light in the combination meter indicates occurrence of a fault or trouble.• Further, against any failure of sensors that would cause ...