Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Manual transmission and differential(6mt) / Switches and harness / Installation

1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH

1. Install the back-up light switch & neutral position switch with the harness.

NOTE:

Use a new gasket.

Tightening torque:

32.3 N·m (3.3 kgf-m, 23.8 ft-lb)

(A)	Neutral position switch
(B)	Back-up light switch

2. Lower the vehicle.

3. Connect the connectors of back-up light switch & neutral position switch.

4. Install the air intake boot. Air Intake Boot > INSTALLATION

5. Connect the ground terminal to battery sensor. NOTE

Inspection

1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal ...

Transfer case and extension case assembly

...

Other materials:

Dtc u0131 lost communication with power steering control module
DTC DETECTING CONDITION:No data is received from power steering CM.TROUBLE SYMPTOM:Cooperation control with power steering CM does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with ...