Subaru Legacy BN/BS (2015-2019) Service Manual: Switches and harness

Installation

1. Install the 1st-2nd fork rod to the 1st-2nd shifter fork through the hole on the rear of the transmission case.2. Align the holes on the 1st-2nd fork rod and 1st-2nd shifter fork, and drive the str ...

Removal

1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intak ...

Other materials:

Dtc b2902 rear height sensor circuit
DTC DETECTING CONDITION:Rear vehicle height sensor error is detected for 10 seconds or more.TROUBLE SYMPTOM:The auto headlight beam leveler does not operate.CAUTION:Initialization is required after replacing the SRF CM.WIRING DIAGRAM:Headlight beam leveler system Headlight Beam Leveler System > WIR ...