Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the clip (A) from the air intake boot. 3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear). 4. Loosen the clamp (C) which connects the air intake boot and throttle body.
5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.
6. Disconnect the connector back-up light switch & neutral position switch.
7. Lift up the vehicle. 8. Remove the back-up light switch & neutral position switch with the harness.
|
Inspection
1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal ...
Other materials:
Installation
1. Install the O-ring to front reduction drive gear.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.2. While holding the torque converter assembly by hand, carefully install it into the torque converter case.NOTE:• Apply CVTF to the oil seal lip.• Do not damage the oil sea ...
