Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Vdc off switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
6 — 8	Switch OFF	1 M- or more
6 — 8	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
4 (+) — 1 (−)	Apply battery voltage.	Light ON

3. Replace the VDC OFF switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Low ...

Installation

1. Install the VDC OFF switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

OFF delay timer
The following lights have an automatic illumination function. dome light map light cargo area light (Outback) After being illuminated automatically, these lights remain on for several seconds and then gradually turn off under the following conditions. after ...