Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Keyless transmitter / Inspection

1. KEYLESS TRANSMITTER BATTERY

1. Measure the keyless transmitter battery voltage.

Preparation tool:

Circuit tester

NOTE:

Complete the measurement within 5 seconds because the battery discharges during measurement.

Battery terminal	Inspection Conditions	Standard
(+) — (−)	Connect resistor (A) 47 -	2.5 — 3.0 V

2. Replace the battery if the inspection result is not within the standard value. (Use CR1620 or equivalent.)

Replacement

1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITORNOTE:• A maximum of four keyless transmitters can be registered for each individual vehicle.• When replacing or adding the ...

1. KEYLESS TRANSMITTER BATTERYCAUTION:To prevent static electricity damage to the keyless transmitter printed circuit board, touch the steel area of building with hand to discharge static electricity ...

Other materials:

Dtc b2a01 lte1 antenna circuit
DIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Any of the followings continues for 5 seconds or more.• LTE1 impedance is more than 1 M-. (Detached antenna, etc.)• LTE1 impedance is less than 1 k-. (Short-circuited antenna, etc.)TROUBLE SYMPTOM:• Telema ...

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Replacement

Removal

Other materials: