Subaru Legacy BN/BS (2015-2019) Service Manual: Replacement
1. REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR NOTE: • A maximum of four keyless transmitters can be registered for each individual vehicle. • When replacing or adding the keyless transmitter, new registration of transmitter is necessary. 1. Register the transmitter. (1) Connect the Subaru Select Monitor to data link connector. NOTE: For detailed operation procedures, refer to “Application help”. (2) Turn the ignition switch to ON. (3) On «Start» display, select «Diagnosis». (4) On «Vehicle selection» display, input the target vehicle information and select «Confirmed». (5) On «Main Menu» display, select «Each System». (6) On «Select System» display, select «Integ. Unit Mode» and select «Enter». (7) On «Select Function» display, select «Work Support». (8) On «Work Support» display, select «Keyless ID registration». (9) According to the directions on the screen, press the button of the transmitter to be registered in the LOCK > UNLOCK order. «When registration completed, external buzzer sound once.» Repeat the registration as many times as desired. (10) Press the [Exit] button to finish the operations. NOTE: When attempting to register a key that has already been registered, the external buzzer sounds twice. |
Inspection
1. KEYLESS TRANSMITTER BATTERY1. Measure the keyless transmitter battery voltage.Preparation tool:Circuit testerNOTE:Complete the measurement within 5 seconds because the battery discharges during mea ...
Other materials:
Installation
1. WATER PUMP PULLEY1. Using the ST, install the water pump pulley.ST1 18355AA000PULLEY WRENCHST2 18334AA030PULLEY WRENCH PIN SETTightening torque:14 N·m (1.4 kgf-m, 10.3 ft-lb)2. Install the V-belts. V-belt > INSTALLATION2. WATER PUMP1. Install the water pump to oil pan upper.NOTE:Use ...
