Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear door latch and door lock actuator assembly / Inspection

1. LATCH

Check if the latch operates normally.

If the cable is faulty, replace the latch & actuator assembly - rear.

2. ACTUATOR

1. Check door lock operation

Check the door lock operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Standard
4 (+) — 1 (−)	Apply battery voltage.	LOCK
1 (+) — 4 (−)	Apply battery voltage.	UNLOCK

2. If it does not operate properly as a result of inspection, replace the latch & actuator assembly - rear.

Removal

1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the trim panel - rear door. Door Trim > REMOVAL4. Remove the sealing ...

Installation

NOTE:Make sure the child safety lock works correctly after installation.1. Before installation, check the following items.• Cable is free from deformation.• Grease is applied sufficiently ...

Other materials:

Removal
1. WATER PUMP PULLEY1. Remove the V-belts. V-belt > REMOVAL2. Remove the water pump pulley using the ST.ST1 18355AA000PULLEY WRENCHST2 18334AA030PULLEY WRENCH PIN SET2. WATER PUMP1. Remove the water pump pulley. Water Pump > REMOVAL2. Drain engine coolant. Engine Coolant > REPLACEMENT3. Rem ...