Subaru Legacy BN/BS (2015-2019) Service Manual: Rear door latch and door lock actuator assembly

Installation

1. Install the push button ignition switch to the visor assembly - lower.2. Install the visor assembly - lower.3. Install the cover assembly - instrument panel LWR driver.4. Connect the ground termina ...

Removal

1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the trim panel - rear door. Door Trim > REMOVAL4. Remove the sealing ...

Other materials:

Assembly
1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling because the taper roller bearing and the outer race are used as a set.ST 927640000INSTALLER(A)Taper roller bearing ( ...