Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Push button ignition switch / Installation

1. Install the push button ignition switch to the visor assembly - lower.

2. Install the visor assembly - lower.

3. Install the cover assembly - instrument panel LWR driver.

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check the continuity between the connectors.Preparation tool:Circuit testerTerminal No.Inspection conditionsSpecification4 (COM) — 5 (GND)AlwaysContinuity exists7 (SSW1) — 5 (GND)Push button ig ...

Rear door latch and door lock actuator assembly

...

Other materials:

Inspection mode procedure
It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.1. INSPECTION MODE 1DTCItemNoteB2600LIN COMMUNICATION — B2601LIN CIRCUIT LOW � ...