Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Push button ignition switch / Inspection

1. Check the continuity between the connectors.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Specification
4 (COM) — 5 (GND)	Always	Continuity exists
7 (SSW1) — 5 (GND)	Push button ignition switch released > pressed	Continuity exists
2 (SSW2) — 5 (GND)	Push button ignition switch released > pressed	Continuity exists

2. Check the push button ignition switch operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Specification
11 (SWIL) — 5 (GND)	Connect battery to the terminals	Goes off > Red switch illumination light
12 (INDS) — 5 (GND)		Turns off > Switch indicator lights in green
13 (INDW) — 5 (GND)		Turns off > Switch indicator lights in orange

3. Replace the push button ignition switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the visor assembly - lower.(1) ...

Installation

1. Install the push button ignition switch to the visor assembly - lower.2. Install the visor assembly - lower.3. Install the cover assembly - instrument panel LWR driver.4. Connect the ground termina ...

Other materials:

Door open indicator
When any of the doors, the rear gate (Outback) or the trunk lid (Legacy) is not fully closed, the door open indicator appears. This function is effective even if the ignition switch is in the "LOCK"/"OFF" or "ACC" position (all models) or the key is removed from the ignition switch (models wi ...