Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear gate latch and actuator assembly / Inspection

1. LATCH

Check if the latch operates normally.

If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.

2. ACTUATOR

Unit inspection

Preparation tool:

Circuit tester

1. Check door lock operation

Check the door lock operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Specification
1 (+) — 2 (−)	Connect battery to the terminals	OPEN

2. Check switch

Check the resistance between connector terminals.

Terminal No.	Inspection conditions	Standard
3 — 4	OPEN	Less than 1.5 -
3 — 4	CLOSE	1 M- or more

3. If it does not operate properly as a result of inspection, replace the latch and actuator - rear gate.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) ...

Installation

1. Install the latch and actuator - rear gate.Tightening torque25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Install the trim panel - rear gate. Rear Gate Trim > REMOVAL3. Connect the ground terminal to ba ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws and remove the memory height switch.(c)Model with SRF(d)Model without SRF ...