Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear gate latch and actuator assembly / Installation

1. Install the latch and actuator - rear gate.

Tightening torque

25 N·m (2.5 kgf-m, 18.4 ft-lb)

2. Install the trim panel - rear gate. Rear Gate Trim > REMOVAL

3. Connect the ground terminal to battery sensor. NOTE

Inspection

1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.2. ACTUATORUnit inspectionPreparati ...

Rear gate opener button

...

Other materials:

Dtc p2195 a/f /o2 sensor signal biased/stuck lean bank 1 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...