Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the stop light switch onto the bracket with screws and position it with the nut. 2. Adjust the stop light switch position, and then tighten the nut. Stop Light Switch > ADJUSTMENT Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) 3. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 4. Install the cover assembly - instrument panel LWR driver. 5. Connect the ground terminal to battery sensor. NOTE |
Adjustment
1. Loosen the lock nut, and adjust the stop light switch position until the clearance (A) between the threaded end of the stop light switch and stopper becomes 1.1 mm (0.04 in). Then, tighten the lock ...
Inspection
1. INSPECT THE SPECIFIED POSITION1. Measure the specified position of the stop light switch ends.Specified position L:3.6 mm ±0.4 mm (0.14 in ±0.016 in)2. Measure the clearance between the end of th ...
Other materials:
Installation
1. SEDAN MODEL1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY2. Install the trunk trim panel - side.3. Connect the ground terminal to battery sensor. NOTE2. OUTBACK MODEL1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY2. ...
