Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Clutch switch / Installation

1. CLUTCH SWITCH

1. Install the clutch switch.

2. Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke.

Clutch pedal full stroke A:

130 — 135 mm (5.12 — 5.31 in)

Tightening torque:

T: 8 N·m (0.8 kgf-m, 5.9 ft-lb)

3. If the clutch pedal stroke is out of specification, adjust the stroke. Clutch Pedal > ADJUSTMENT

4. Connect the connector to the clutch switch.

5. Thereafter, install in the reverse order of removal.

2. CLUTCH START SWITCH

1. Install the clutch start switch.

2. Fully depress the clutch pedal and hold it.

3. Install so that gap (A) of the clutch pedal plate and clutch start switch is 2.9 mm (0.11 in), and tighten the lock nut.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

(A)	2.9 mm (0.11 in)
(B)	Clutch pedal plate
(C)	Clutch start switch
(D)	Lock nut

4. Connect the connector to the clutch start switch.

5. Make sure that engine does not start with clutch pedal not depressed.

6. Make sure that engine starts with clutch pedal fully depressed.

7. Thereafter, install in the reverse order of removal.

Adjustment

1. Loosen the lock nut of the clutch start switch.2. Fully depress the clutch pedal and hold it.3. Adjust the gap (A) of the clutch pedal plate and the clutch start switch to be 2.9 mm (0.11 in).(A)2. ...

Inspection

1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT• Make sure th ...

Other materials:

Operation
1. BRAKE MAINTENANCE MODECAUTION:• DTCs may be stored after starting the brake maintenance mode. When the brake maintenance mode is complete, clear the DTCs.• When the brake maintenance mode is completed, the electronic parking brake automatically operates. Check if any other works are n ...