Subaru Legacy BN/BS (2015-2019) Service Manual: Adjustment

Subaru Legacy BN/BS (2015-2019) Service Manual / Clutch system / Clutch switch / Adjustment

1. Loosen the lock nut of the clutch start switch.

2. Fully depress the clutch pedal and hold it.

3. Adjust the gap (A) of the clutch pedal plate and the clutch start switch to be 2.9 mm (0.11 in).

(A)	2.9 mm (0.11 in)
(B)	Clutch pedal plate
(C)	Clutch start switch
(D)	Lock nut

4. Tighten the lock nut.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the instrument panel lower cover. Instrument Panel Lower Cover > REMOVAL3. Disconnect the connector from the clutch switch and cl ...

Installation

1. CLUTCH SWITCH1. Install the clutch switch.2. Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke.Clutch pedal f ...

Other materials:

Installation
1. Temporarily install the drive plate and reinforcement drive plate.2. Set the ST.NOTE:Set the ST to the drive plate referring to the illustration.ST 498497300CRANKSHAFT STOPPER3. Tighten the drive plate mounting bolt in two stages.NOTE:Fix the engine unit.(1) Tighten the drive plate mounting bo ...