Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the sensor assembly - headlight beam leveler. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the rear wheels. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE 5. Perform reinitialization of the auto headlight beam leveler system. Auto Headlight Beam Leveler System > PROCEDURE NOTE: When replacing the rear vehicle height sensor with a new part, perform the initialization. Auto Headlight Beam Leveler System > PROCEDURE |
Inspection
Preparation tool:Circuit tester1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using circuit tester, check that the initial voltage of a single dr ...
Other materials:
Electrical component location location
(1)Power rear gate drive unit (PRG DU)(3)Rear gate opener button(4)Power rear gate buzzer(2)Power rear gate control module (PRG CM) (1)Power rear gate inner switch(3)Rod - power rear gate(5)Power rear gate touch sensor(2)Gas damper(4)Power rear gate auto closer (1)Power rear gate driver’s ...
