Subaru Legacy BN/BS (2015-2019) Service Manual: Rear height sensor

Installation

1. SEDAN MODEL1. Replace the light assembly gasket with a new part.2. Install the rear finisher light assembly.3. Install the garnish - trunk.Tightening torque:4.5 N·m (0.5 kgf-m, 3.3 ft-lb)4. ...

Removal

CAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicl ...

Other materials:

Read cancel code operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select «Engine Control System».5. Drive vehicle at 40 km/h (25 MPH) ...