Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear finisher light assembly / Installation

1. SEDAN MODEL

1. Replace the light assembly gasket with a new part.

2. Install the rear finisher light assembly.

3. Install the garnish - trunk.

Tightening torque:

4.5 N·m (0.5 kgf-m, 3.3 ft-lb)

4. Install the trim panel - trunk lid.

5. Connect the ground terminal to battery sensor. NOTE

2. OUTBACK MODEL

1. Replace the light assembly gasket with a new part.

2. Install the rear finisher light assembly.

3. Install the garnish assembly - rear gate.

Tightening torque:

4.5 N·m (0.5 kgf-m, 3.3 ft-lb)

4. Install the trim panel - rear gate.

5. Connect the ground terminal to battery sensor. NOTE

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL3. Remove the garnish - trunk. Trunk Lid Garnish > REMOVAL4. ...

Rear height sensor

...

Other materials:

Inspection
1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsStandardCircuit1 — 2Always1 M- or mor ...