Subaru Legacy BN/BS (2015-2019) Service Manual: Rear finisher light assembly

Disassembly

CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. TAIL LIGHT/STOP LIGHT BULBNOTE:Since the LED type is a non-disassembled part, it cannot be removed. ...

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL3. Remove the garnish - trunk. Trunk Lid Garnish > REMOVAL4. ...

Other materials:

Inspection
1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT• Make sure that engine does not start with clutch pedal not depressed.• Make sure that engine starts with c ...