Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Secondary speed sensor / Installation

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.

1. Install the secondary speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

2. Connect the harness connector.

3. Install the transmission cover.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

4. Install the transmission assembly. Automatic Transmission Assembly > INSTALLATION

Inspection

1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscillo ...

Torque converter assembly

...

Other materials:

Inspection
WARNING:• As batteries produce flammable gases, be careful not to bring an open flame close to the batteries.• Ventilate sufficiently when using or charging battery in enclosed space.• Electrolyte is corrosive acid, and has toxicity; be careful of handling the fluid.• For saf ...