Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Connect the connector to the fuel pump control module. 2. Install the fuel pump control module. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 3. Install the trunk trim panel assembly - side on RH side. (Sedan model) Rear Quarter Trim > INSTALLATION 4. Install the right side rear quarter trim. (OUTBACK model) Rear Quarter Trim > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE |
Inspection
Check that the fuel pump control unit has no deformation, cracks or other damages. ...
Fuel pump relay
...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the clip (A) from the air intake boot.4. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).5. Loosen the clamp (C) which connects the air intak ...
© 2017-2026 Copyright www.sulegacy.com
