Subaru Legacy BN/BS (2015-2019) Service Manual: Fuel pump control unit

Installation

1. Install the fuel pump assembly to the fuel tank.CAUTION:Set the arm and float of the fuel level sensor while paying attention to prevent them from contacting the fuel tank. If the arm of the fuel l ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel assembly - side on the RH side. (Sedan model) Rear Quarter Trim > REMOVAL3. Remove the right side rear quart ...

Other materials:

Installation
CAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• After installing the secondary pressure sensor, adjust the CVTF level.1. Install the secondary pressure sensor.NOTE:• Use new ...