Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Rear side marker light bulb / Installation

1. SEDAN MODEL

1. Install the rear side marker light bulb. Rear Combination Light Assembly > ASSEMBLY

2. Install the trunk trim panel - side.

3. Connect the ground terminal to battery sensor. NOTE

2. OUTBACK MODEL

1. Install the rear side marker light bulb. Rear Combination Light Assembly > ASSEMBLY

2. Install the light assembly - rear combination.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

3. Connect the ground terminal to battery sensor. NOTE

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the rear side marker light bulb. Rear Combination ...

Rear turn signal light bulb

...

Other materials:

General diagnostic table inspection
1. IMMOBILIZER SYSTEMSymptomsNoteEngine does not start Diagnostics with Phenomenon > INSPECTION Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2784 ANTENNA CIRCUIT (PUSH ENGINE SWITCH) Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B278A PUSH ENGINE SWITCH POWER SUPPLY ...