Subaru Legacy BN/BS (2015-2019) Service Manual: Rear turn signal light bulb

Installation

1. SEDAN MODEL1. Install the rear side marker light bulb. Rear Combination Light Assembly > ASSEMBLY2. Install the trunk trim panel - side.3. Connect the ground terminal to battery sensor. NOTE2. OU ...

Removal

1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the rear turn signal light bulb. Rear Combination ...

Other materials:

Dtc b1652 half connection in airbag sensor assembly connector
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Connection failure of airbag CM connectorCAUTION:Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTIONSTEPCHECKYESNO1.CHECK CONNECTOR.Check fo ...