Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SEDAN MODEL 1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY 2. Install the trunk trim panel - side. 3. Connect the ground terminal to battery sensor. NOTE 2. OUTBACK MODEL 1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY 2. Install the light assembly - rear combination. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE |
Removal
1. SEDAN MODEL1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL3. Remove the rear turn signal light bulb. Rear Combination ...
Reflex reflector
...
Other materials:
Dtc c1922 hill hold switch circuit
DTC DETECTING CONDITION:A fault is detected if the hill hold switch is pressed and held for a long period of time.TROUBLE SYMPTOM:Hill hold function cannot be set.WIRING DIAGRAM:NOTE:For the coupling connector, refer to “WIRING SYSTEM”.Parking brake / brake fluid level warning light syst ...
