Subaru Legacy BN/BS (2015-2019) Service Manual: Removal
1. SEDAN MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trunk trim panel - side. Trunk Room Trim > REMOVAL 3. Remove the rear turn signal light bulb. Rear Combination Light Assembly > DISASSEMBLY 2. OUTBACK MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the light assembly - rear combination. Rear Combination Light Assembly > REMOVAL 3. Remove the rear turn signal light bulb. Rear Combination Light Assembly > DISASSEMBLY |
Installation
1. SEDAN MODEL1. Install the rear turn signal light bulb. Rear Combination Light Assembly > ASSEMBLY2. Install the trunk trim panel - side.3. Connect the ground terminal to battery sensor. NOTE2. OU ...
Other materials:
Malfunction indicator light does not come on
TROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.STEPCHECKYESNO1.CHECK DTC.Is DTC of LAN system displayed- Read Diagnostic Trouble Code (DTC) > OPERATIONCheck the appropriate DTC using the “List of Diagnostic Trouble Code ( ...
