Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • When replacing the body integrated unit, install the starter relay (a) to the relay holder.
NOTE: Make sure that there are no differences from the contents of the current settings after installation. Read Current Data > LIST 1. Install the body integrated unit (fuse & relay box). Tightening torque: Relay & fuse box: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 2. Install the panel - knee guard. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 3. Install the cover assembly - instrument panel LWR driver. 4. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Low ...
Note
1. WHEN REPLACING THE BODY INTEGRATED UNIT1. Check and record the current setting. Registration Body Integrated Unit > OPERATIONCAUTION:• When the body integrated unit is replaced, registration ...
Other materials:
Inspection mode procedure
Perform the diagnosis shown in the following DTC table.When performing the diagnosis not listed in “List of Diagnostic Trouble Code (DTC)”, refer to the item on the drive cycle. Drive CycleDTCItemConditionB1570ANTENNA — B1571REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM) — B ...
