Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear lock button / Installation

CAUTION:

Make sure that the harness grommet is securely installed.

If not properly installed, this may cause leaks.

1. Install the rear lock button and the switch - opener rear gate.

2. Install the garnish assembly - rear gate. Rear Gate Garnish > INSTALLATION

Tightening torque

4.5 N·m (0.4 kgf-m, 3.3 ft-lb)

3. Install the trim panel - rear gate. Rear Gate Trim > INSTALLATION

4. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Using the Subaru Select Monitor, display «Rear gate/Trunk UNLOCK output» from «Data monitor».2. Check if the display changes when the rear lock button is operated.3. If the display is not corre ...

Rear outer handle

...

Other materials:

Dtc p0196 engine oil temperature sensor "a" range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start• Improper idling• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspectio ...