Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Rear lock button / Inspection

1. Using the Subaru Select Monitor, display «Rear gate/Trunk UNLOCK output» from «Data monitor».

2. Check if the display changes when the rear lock button is operated.

3. If the display is not correct as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION

Removal

NOTE:• The rear lock button is integrated with the switch - opener rear gate.• Open the panel - rear gate before disconnecting the ground terminal from battery sensor.1. Disconnect the gro ...

Installation

CAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.1. Install the rear lock button and the switch - opener rear gate.2. Install the garnis ...

Other materials:

System maintenance
NOTE For models without "keyless access with push-button start system": In the event that the vehicle's battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is r ...