Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Before installation, check the following items. • Lever is free from deformation. • Grease is applied sufficiently to lever joints. If grease is insufficient, add it as necessary before assembling. 2. Install the frame assembly - rear door outer. Preparation tool: TORX® T30 Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the spacer - door handle outer. 4. Install the handle - door outer. (1) Insert the end of the handle - door outer to the frame assembly - rear door outer. (2) Push forward while inserting the rear end of the handle - door outer to the frame assembly - rear door outer. 5. Install the cover - handle rear outer. Preparation tool: TORX® T30 Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 6. Install the latch and actuator assembly - rear. CAUTION: Do not re-use the screws. Always replace with a new part. Tightening torque: 6.5 N·m (0.7 kgf-m, 5.2 ft-lb) 7. Install the sealing cover - rear door. 8. Install the trim panel - rear door. Door Trim > INSTALLATION 9. Connect the ground terminal to battery sensor. NOTE |
Inspection
Check if the outer handle operates normally.If the lever is faulty, replace the handle - door outer. ...
Relay and fuse
...
Other materials:
Dtc p0018 crankshaft position - camshaft position correlation bank 2 sensor a
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCE ...
