Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the EGR pipe adapter to the EGR control valve. NOTE: Use a new gasket. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 2. Install the EGR control valve to the intake manifold assembly, and connect the connector to the EGR control valve. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 3. Install the bolts securing the EGR cooler to the EGR control valve. Tightening torque: 9 N·m (0.9 kgf-m, 6.6 ft-lb) NOTE: Use a new gasket. 4. Tighten the bolts holding the EGR cooler to the cylinder head RH. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 5. Install the EGR pipe. EGR Pipe > INSTALLATION 6. Install the air intake boot. Air Intake Boot > INSTALLATION 7. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. Check that the EGR control valve has no deformation, cracks or other damages.2. Measure the resistance between EGR control valve terminals.Terminal No.Standard2 and 122±2 -2 and 322±2 -5 and 422 ...
Egr cooler
...
Other materials:
Selecting reverse gear
CAUTION
Shift into reverse ONLY when the
vehicle has completely stopped. It
may cause damage to the transmission
to try shifting into reverse when
the vehicle is moving.
1) Slider
You must raise the slider and hold it in that
position before you can move the shift
...
