Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Before installation, inspect the following items and replace any faulty part with a new part. • The front door impact sensor or connector is damaged. • Inner panel area of the panel assembly - front door is deformed. • Plate - door is deformed. • Side airbag module has been activated. 2. Install the front door impact sensor. CAUTION: • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • Thoroughly clean the sensor mounting area before installing the front door impact sensor. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Install the sealing cover. 4. Install the trim panel - front door. 5. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:• Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION• When the front door impact senso ...
Front sub sensor
...
Other materials:
Dtc u0075 control module communication bus "pu-can" off
DTC DETECTING CONDITION:Integrated unit communication is shut down because of high speed CAN error.TROUBLE SYMPTOM:CAN communication is not normal.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagn ...
