Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • If the airbag has been activated, replace the front sub sensor with a new part. • Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts. • When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely. 1. Before installation, inspect the following items and replace any faulty part with a new part. • Front sub sensor or connector is damaged. 2. Install the front sub sensor. Tightening torque: 13 N·m (1.3 kgf-m, 9.6 ft-lb) 3. Install the air intake duct. (When removing the sensor RH) 4. Connect the ground terminal to battery sensor. NOTE |
Removal
CAUTION:Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION1. Turn the ignition switch to OFF.2. Disconnect ...
Other materials:
Removal
1. CYLINDER HEAD RH1. Remove the engine from the vehicle. Engine Assembly > REMOVAL2. Remove the intake manifold assembly. Intake Manifold Assembly > REMOVAL3. Remove the engine wiring harness. Engine Wiring Harness > REMOVAL4. Remove the chain cover. Chain Cover > REMOVAL5. Remove the rocker co ...
