Subaru Legacy BN/BS (2015-2019) Service Manual: Manual transmission assembly

Assembly

NOTE:• Match the alignment marks, and install the coupling sleeve and then install the shifting insert.• Make sure that there is no large clearance at both sides of the shifting insert aft ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the clip (A) from the air intake boot.4. Loosen the clamp (B) connecting ...

Other materials:

Installation
CAUTION:• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT• Before ...